NoBow ShoeTie  
 
  NoBow ShoeTie Instructions
Step 1
Place the NoBow-ShoeTie over the shoe. Take note of how the holes in the NoBow align with the laces of the shoe. The laces of the shoe can be laced through the holes in NoBow to hold it securely in place. It is best to have the top of the shoe tie below the top of the shoe tongue. On this shoe the holes in the NoBow align with the second and third crosses of the laces. This is where we will install the NoBow.
click to enlarge
Step 2
Unlace the shoe down to the cross that aligns with the bottom hole in the NoBow.
click to enlarge
Step 3
The top of the NoBow is marked “TOP”. The four ears are on the top of the NoBow. The two ridges are on the bottom. Lace through the bottom hole of the NoBow and return the laces to the SAME side of the shoe they started on. This usually works best if laces are fed up through the holes from bottom to top.
click to enlarge
Step 4
Repeat step 3 running the laces through the top hole in the NoBow. Be sure to return the laces to the same side of the shoe they started on.
click to enlarge
Step 5
Cross the laces behind the NoBow and lace through the remaining eyes normal fashion.
click to enlarge
Step 6
To tie the shoe, pull the laces tight with one hand. Pull them over the tie and through a notch on the lower part of the NoBow.
click to enlarge
Step 7
Wrap the laces in a figure eight around the NoBow. Repeat until the lace ends are of appropriate length. With just a little practice the tying of the shoe can be done with one hand. The knot created is far more secure than a normal bow tie of the shoe.
click to enlarge
   
 

353 Ivyland Road
Warminster, PA 18974

info@Nobow-shoetie.com